Causes of water leakage of toilet flush valve trea

2022-07-22
  • Detail

We will encounter various problems in our daily life, which make many people headache, such as the leakage of the toilet flush valve. We must first check the causes of the leakage of the toilet flush valve, and then take some treatment methods. Then the following editor will introduce the causes of the leakage of the toilet flush valve and its treatment methods. Let's have a look

in daily life, we will encounter various problems, which give many people a headache, such as the leakage of the toilet flush valve. We must first check the causes of the leakage of the toilet flush valve, and then take some treatment methods. Then the following editor will introduce the causes of the leakage of the toilet flush valve and its treatment methods. Let's have a look

causes of water leakage of toilet flushing valve

1. The rod of this flushing valve is rigidly connected with the valve, and the guide rod of the internal device is connected with the handle cantilever. When we open the rotating handle, the cantilever and the upper guide rod need to make circular arc movement, and the radial movement of the guide rod is limited in the guide bracket, so the metal guide rod is pulled, bent and deformed, As a result, the guide rod is stuck on the guide support, and the rubber valve cannot fall down, resulting in incorrect reset, failure to seal and water leakage

2. When the water level in the water tank is high, the floating ball will rise until the floating arm presses the valve plunger into the floating ball valve and closes the incoming water flow; If the water cannot be turned off, the excess water will flow down the overflow pipe

treatment method for leakage of toilet flush valve

1. Lift the floating arm upward; If the water flow stops, the floating ball cannot be raised to a certain height, and the valve plunger is pressed into the floating ball valve, which may be due to the friction between the floating ball and the side wall of the water tank. If this is the case, bend the floating arm slightly to make the floating ball leave the side wall of the water tank

2. If the floating ball does not contact the water tank, grasp it with the floating arm, then rotate the floating ball counterclockwise, slowly remove it, and then shake the floating ball to see if it has water, because too much water will make the floating ball unable to rise normally. If there is water, throw out its water, and then install it in place; If the floating ball is damaged or corroded, it needs to be replaced with a new one. If there is no one in the floating ball, gently bend the floating rod to the lowest position to prevent the floating ball from entering the water tank

3. If the above methods are invalid, then it is necessary to adhere to the water tank ball plug at the valve seat of the lower flushing valve. It may be that the ball plug cannot be moved to the appropriate position due to the residue in the water, or the ball plug has been corrupted, and the water leaks from the opening of the flushing valve to the barrel below; Close the closing valve of the toilet, then flush and drain the water in the tank. If the water tank ball plug is worn, it needs to be reinstalled

editor's summary: the above is about the causes of the leakage of the toilet flush valve and the treatment methods of the leakage of the toilet flush valve. Everyone also knows the causes and treatment methods of the leakage of the toilet flush valve. I hope it will be helpful to you. If you want to know the relevant content, you can pay attention to the information

成都肝病医院

南宁男科医院

沈阳男科医院

Copyright © 2011 JIN SHI